Fluke 434 User Manual download pdf (Page 79)

18-1

Chapter 18

Setting up the Analyzer

Introduction

The SETUP key accesses menus to view and change Analyzer settings. At delivery the

Analyzer is adjusted to settings that match your local situation and the supplied

accessories. The table below gives an overview:

Setting Preset Value

Nominal Voltage 120 V or 230 V

Nominal Frequency 60 Hz or 50 Hz

Displacement Power Factor DPF or Cos φ

Phase Identification A,B,C or L1,L2,L3

Phase Colors A/L1-B/L2-C/L3-N-Ground Black-Red-Blue-Gray-Green or

Black-Red-Gray-Blue-Green/Yellow or

Red-Yellow-Blue-Black-Green/Yellow or

Black-Black-Black-Blue-Green/Yellow

Date Format Month/Day/Year or Day/Month/Year

If desired the settings in the table can be changed by the user.

Also other settings such as offset and span of trend and waveform displays are set to

Factory Default values. This will give good readings in almost all situations and allows

you to start measurements almost immediately.

At power-on a welcome screen is displayed that shows settings currently in use. Check if

Date and Time of the system clock are correct. Also the wiring Configuration must match

the configuration of the power system to be checked. The wiring Configuration is

available under Function key F1.

If necessary adjust Date, Time, and Config. How to do this is explained in section

‘General Settings’. The welcome screen is shown in the Figure below.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 121 122

No comments

Fluke 434 User Manual Page 79