Fluke 434 User Manual download pdf (Page 27)

6-1

Chapter 6

Input Connections

Introduction

This chapter explains how to make connection to the power distribution system under test

and how to adjust the Analyzer settings.

Check that the Analyzer setup meets the characteristics of the system under test and the

accessories that are used. This concerns:

• wiring configuration

• nominal frequency

• nominal voltage

• properties of voltage leads and current clamps

The actual setup is shown in the welcome screen that appears after power up. To change

the setup, refer to Chapter 18.

Input Connections

The Analyzer has 4 BNC-inputs for current clamps and 5 banana-inputs for voltages.

Self-adhesive decals are supplied corresponding to wiring color codes used in the USA,

Continental Europe, the UK, and China. Stick the decals that fit to your local wiring

codes around the current and voltage inputs as shown in Figure 6-1.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 121 122

No comments

Fluke 434 User Manual Page 27