Fluke 5020A User Manual download pdf (Page 83)

Digital Communications Interface

Commands 6

6-13

• <hour> indicates a one or two digit number for the hour (0 to 23) is required.

• <minute> indicates a one or two digit number for the minute is required.

• <second> indicates a one or two digit number for the second is required.

• <baud> indicates a valid baud rate setting is required.

• For query commands, specifying the MIN, MAX, or DEF parameter causes the

instrument to respond with the minimum, maximum, or default setting

respectively.

• For set commands, specifying the MIN, MAX, or DEF parameters causes the

instrument to use the minimum, maximum, or default setting respectively.

• Unrecognized commands or commands with incorrect syntax or invalid

parameters generate error messages that are placed in the error queue (see

SYST:ERR?).

Alarm Commands

ALARm:BATTery?

Indicates whether a battery alarm event has occurred.

Example: ALAR:BATT?

Response: 1

A value of 1 is returned if a battery alarm event has occurred. A value of 0 is returned if a

battery alarm event has not occurred.

ALARm:BATTery:ENABle?

Returns the state of the battery alarm enable.

Example: ALAR:BATT:ENAB?

Response: 0

A value of 1 is returned if the battery alarm is enabled. A value of 0 is returned if the

battery alarm is disabled.

ALARm:BATTery:ENABle <bool>

Sets the state of the battery alarm enable.

Example: ALAR:BATT:ENAB 1

The <bool> parameter turns the battery alarm enable on (1 or ON) or off (0 or OFF). This

command may be password protected (see Password Commands).

ALARm:BEEP?

Returns the state of the audible alarm enable.

Example: ALAR:BEEP?

Response: 0

A value of 1 is returned if the alarm beep is enabled. A value of 0 is returned if the alarm

beep is disabled.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 141 142

No comments

Fluke 5020A User Manual Page 83