Fluke LinkRunner Specifications download pdf (Page 33)

LinkRunner AT 1000/2000 Network Auto-Tester

Users Manual

FFY53.png

Figure 26. AutoTest results - PoE with TruePower and

Measured Load

Using the Reflector Feature (LR-AT

2000 only)

The Reflector feature allows the LR-AT 2000 to be used as a

remote device for Fluke Networks EtherScope Network

Assistant, MetroScope Service Provider, and the OptiView

Analyzer’s throughput performance tests.

See Reflector Configuration on page 15 for setting up this

feature. Once set up, the device can be used as the remote

responding device for throughput performance testing.

There is no start or stop, and no results are displayed on the

tester.

Using the Fiber Connection

Simply plug in the desired SFP adapter into the fiber port

on the top of the tester and connect the fiber cable to the

network. If both fiber and RJ-45 copper are connected to

the network, the copper connection has priority.

Figure 27 shows the Switch results through a fiber

connection with link, 1000 Mbps speed, full duplex, with a

signal strength of 7.35dBm.

ffy46.bmp

Figure 27. Fiber Connected Switch Results

PoE Request

Indicates

test

failure

PSE

acknowedg-

ment

Measured

with load

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39

No comments

Fluke LinkRunner Specifications Page 33