Fluke LinkRunner Specifications download pdf (Page 27)

LinkRunner AT 1000/2000 Network Auto-Tester

Users Manual

Set Language

To change the language displayed in all screens

Select Tools > Set Language.

Highlight a language and press  Save.

Using AutoTest, Switch, and Cable Test

Using AutoTest

AutoTest can test up to ten targets. These targets can be

local or off-net targets (devices). You can enter the IP

address or a DNS name. If you specify a target address

without specifying a port number, AutoTest will perform an

ICMP Ping to the target address. If you specify a port

number, AutoTest will perform a TCP Connectivity test (SYN/

ACK). See figures 15 and 16.

Select Tools > AutoTest Configuration and enter the target

address(s). Entering a port number is optional.

AutoTest will attempt to Ping/Connect to the target device

three times. If Continuous is selected, the test will run until

you exit the AutoTest screen.

ffy28.bmp

Figure 15. AutoTest Configuration Screen

Select AutoTest on the Home screen. AutoTest will run and

the test results should look similar to figure 16.

ffy27.bmp

Figure 16. AutoTest Results Screen

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 38 39

No comments

Fluke LinkRunner Specifications Page 27