Fluke LinkRunner Specifications download pdf (Page 20)

Set Up the Tester

AutoTest Configuration

Select Tools > AutoTest Configuration.

ffy42.bmp

Figure 8. AutoTest Configuration Screen

This screen allows you to enter up to ten key device

addresses (Targets) to test connectivity. You may enter an IP

address, URL, or DNS name. If no port is specified, AutoTest

will perform an ICMP Ping test to that address. If a port is

specified, AutoTest will perform a TCP Connectivity test

(SYN/ACK).

The Continuous Mode check box allows the test to run

continuously (checked) or one time (un-checked). When

you exit the AutoTest screen, the test is stopped.

PoE Configuration

Select Tools > PoE Configuration.

ffy34.bmp

Figure 9. PoE Configuration Screen

By default, PoE is disabled. This screen allows you to enable/

disable PoE detection, Enable TruePower

, and set the Class

for detection. If you enable PoE and select Class 4 (25.5W),

you can also enable LLDP Negotiation so that PoE is only

reported if that criteria is met.

PoE TruePower

is only available on the LR-AT 2000 model.

TruePower

puts a load on the PoE device and gives an

accurate measurement on whether the device supports the

Class selected. See also, “Using the PoE Feature” on page

23.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 38 39

No comments

Fluke LinkRunner Specifications Page 20