Fluke LinkRunner Specifications download pdf (Page 19)

LinkRunner AT 1000/2000 Network Auto-Tester

Users Manual

IP Configuration

Select Tools > IP Configuration.

ffy40.bmp

Figure 6. IP Configuration Screen

This screen allows you to enter an IPv4 address or use a

DHCP address (default). It also allows you to enable IPv6

addressing (LR-AT 2000 only). LR-AT uses the IP address

during AutoTest. During AutoTest, the LR-AT is required to

connect to the network for Ping and TCP Connectivity

testing.

At no other time, does the LR-AT connect to the network

using IP addressing. This applies to the Switch and Cable

test screens.

VLAN/MAC Configuration

Select Tools > VLAN/MAC Configuration.

ffy41.bmp

Figure 7. VLAN/MAC Configuration Screen

This screen allows you to enable and enter the VLAN ID and

its Priority level. By un-checking the VLAN check box, the

VLAN capability is disabled.

This screen also allows you to enable and enter a user

defined MAC address. By un-checking the Enable User

Defined MAC check box, the LR-AT reverts back to the

factory default MAC address.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 38 39

No comments

Fluke LinkRunner Specifications Page 19