Fluke Ti20 User Manual download pdf (Page 25)

2-1

Chapter 2

Basic Operation

Turning the Imager On and Off

Use the G key to turn the Imager on and off. To turn on the Imager, press and hold the

G for approximately 2 seconds until the date and time appear in the upper right-hand

corner of the display. The Imager splash screen appears until the Imager can reliably

show an accurate thermal image. After approximately 5 seconds, the Imager loads the

Home display.

The Imager splash screen is shown in Figure 2-1 and displays the following information:

• Date and Time

• Fluke and MicroIR logos

• Model Number

• Serial Number

• Firmware Version

• Route Name (if uploaded to Imager)

dag102f.eps

Figure 2-1. Imager Splash Screen

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 67 68

No comments

Fluke Ti20 User Manual Page 25