Fluke NetDAQ 2645A User Manual download pdf (Page 239)

Noise, Shielding, and Crosstalk Considerations

Crosstalk Considerations

B-3

the routing of your input wiring: keep it away from or shielded from all ac

power mains wiring and other sources of noise.

3. Channel Spacing When possible, leave as many unused channels as possible

between your ac voltage channel inputs and your low level inputs.

Crosstalk from a VAC or frequency signal on a 2645A channel to an adjacent

channel using the Slow reading rate is as shown in Table B-1:

Table B-1. 2645A Crosstalk Specifications.

VAC/Frequency Volts DC Resistance

Temperature

(100 Ohm RTD)

Temperature

(Thermocouple)

<100 Hz -80 dB .2%/V if R>3k .04°/V .1°/V

100 Hz -100 dB .1%/V if R>3k .02°/V .003°/V

500 Hz -100 dB .1%/V if R>3k .02°/V .03°/V

1 kHz -50 dB .1%/V if R>3k .02°/V .3°/V

2 kHz -60 dB .05%/V if R>3k .02°/V .1°/V

5 kHz -66 dB .1%/V if R>3k .02°/V .1°/V

10 kHz -80 dB .01%/V .02°/V .1°/V

20 kHz -50 dB .02%/V .05°/V .1°/V

50 kHz -40 dB .05%/V .1°/V .5°/V

100 kHz -40 dB .1%/V .2°/V 1°/V

>100 kHz -40 dB .1%/V .4°/V 2°/V

Note 1 The temperature ranges are particularly susceptible to crosstalk at frequencies above 20

kHz, and that the error goes up as the square of the voltage, e.g., 2V ac at 100 kHz can cause a

4 degree error on a thermocouple. Because of this sensitivity, it is not advisable to mix

temperature signals and high frequency signals in the same 2645A.

1 2 ... 234 235 236 237 238 239 240 241 242 243 244 ... 352 353

No comments

Fluke NetDAQ 2645A User Manual Page 239