Fluke 1060AM-NM-LRVAR User Manual

1060AM-NM-LRVAR Local, Remote, and Flasher Alarms Operators Manual March 2005 Manual No. 1060AMNMLRVAR-1 Rev. 1 ©2004,

1060AM-NM-LRVAR Operators Manual 2-4 2.6 Electrical interface The Local alarm (1060-024) requires power connections as follows: (See appendix A fo

InstructionsOperation2 2-52.7 Operation The red beacons and red leds are ON . The flasher alarm is blinking . Connect the free end of the I/O (10

1060AM-NM-LRVAR Operators Manual (Blank Page)

MaintenanceMaintenance and Cleaning3 3-1Section 3 Maintenance and Cleaning To prevent injury, do not remove or in

1060AM-NM-LRVAR Operators Manual 3-2 1. Slide the acrylic yellow panel out from either side of the chassis . To prevent property damage and

AppendixApplicable Drawings and Parts ListA A-1Appendix A Applicable Drawings and Parts List 4.1 Applicable Drawings and Parts List 1060-005 Main

Fluke Biomedical Radiation Management Services 6045 Cochran Road Cleveland, Ohio 44139 440.498.25

Fluke Biomedical Radiation Management Services 6045 Cochran Road Cleveland, Ohio 44139 440.498.256

iTable of Contents Section 1: Introduction... 1-1 1.1

(Blank Page)

IntroductionProcedures, Warnings and Cautions1 1-1Section 1 Introduction 1.1 Procedures, Warnings and Cautions • The equipment described in this m

1060AM-NM-LRVAR Operators Manual (Blank Page)

InstructionsGeneral Description2 2-1Section 2 Instructions 2.1 General Description Refer to 1060-005 drawing located in Appendix A . The Fluke Biom

1060AM-NM-LRVAR Operators Manual 2-2 Electrical Requirements 120 VAC 50/60 Hz 120 VAC 50/60 Hz 120 VAC 50/60hz 2.3 Receiving Inspection Upon

InstructionsInstallation2 2-32.5 Installation To prevent electrical shock, ensure that power is disconnected before installing the alarms Insta